📐 Post & Hole Settings
posts
✓ Results
Number of Posts 14
Concrete per Post 0.92 cu ft
Total Concrete (cubic feet) 12.89 cu ft
0.48 cu yd
Total Cubic Yards

Bags Needed:

50 lb bags (~$5 each)
35
~$175.00
80 lb bags (~$6.50 each)
22
~$143.00

Need to calculate your full fence materials?

Use our Fence Calculator →

Need concrete for slabs or footings?

Use our full Concrete Calculator →

How Much Concrete Per Fence Post?

The amount of concrete you need per fence post depends on the post size, hole diameter, and hole depth. Here is a quick reference:

Post Size Hole Depth Concrete 50 lb Bags
4×4 10" dia 24" 0.92 cu ft ~2.5 bags
4×4 10" dia 36" 1.38 cu ft ~3.7 bags
6×6 12" dia 24" 1.15 cu ft ~3.1 bags
6×6 12" dia 30" 1.44 cu ft ~3.8 bags
6×6 12" dia 36" 1.73 cu ft ~4.6 bags

The Formula

Concrete per post hole is the volume of the cylindrical hole minus the volume taken up by the square post:

Hole Volume = π × (hole_diameter / 2)² × depth
Post Volume = post_width² × depth
Concrete per Post = Hole Volume - Post Volume

All measurements are converted to feet before calculating. A 50 lb bag of concrete fills approximately 0.375 cubic feet, and an 80 lb bag fills approximately 0.6 cubic feet.

On this page

  1. How Much Concrete Per Fence Post?
  2. Fence Post Installation Tips
  3. Fence Post Pro Tips & Mistakes to Avoid
  4. Frequently Asked Questions

Fence Post Installation Tips

Hole Size Guidelines

Fast-Setting vs Regular Concrete

Crown the Concrete

Shape the top of the concrete so it slopes away from the post on all sides. This "crowning" prevents water from pooling against the post, which causes rot and shortens the lifespan of wood posts.

Fence Post Pro Tips & Mistakes to Avoid

Pro Tips

Mistakes to Avoid

Frequently Asked Questions

How many bags of concrete per fence post?

For a standard 4×4 post in a 10" diameter hole at 24" deep, you need about 2.5 bags (50 lb) of concrete per post, so buy 3. For a 6×6 post in a 12" hole at 30" deep, plan on about 4 bags per post. Use the calculator above for an exact count based on your specific setup.

Should I use fast-setting or regular concrete?

For most DIY fence post installations, fast-setting concrete is the best choice. You pour the dry mix directly into the hole, add water, and the post is set in about 20-40 minutes. No mixing tub or wheelbarrow needed. Regular concrete works fine but requires pre-mixing and 24-48 hours of cure time before you can work on the fence.

How long before I can attach fence rails?

With fast-setting concrete, you can typically attach rails and fence panels after about 4 hours. With regular concrete, wait at least 24-48 hours before putting any load on the posts. In cold weather, add extra cure time regardless of the concrete type.

Can I set fence posts without concrete?

Yes, in firm, well-drained soil you can set fence posts using compacted gravel or crushed stone. This method improves drainage around the post base and can extend the life of wood posts. However, concrete provides significantly more rigidity and holding strength, especially for tall fences, gates, or areas with soft or sandy soil.

How deep should fence post holes be?

Bury one third of the fence's above-ground height or 2 feet, whichever is deeper, and always below the local frost line. A 6-foot fence typically uses 8-foot posts set 2 feet deep, or 9-foot posts set 3 feet deep where wind or frost calls for more.

How wide should a fence post hole be?

About three times the post width — so 10–12 inches for a 4x4 and 16–18 inches for a 6x6, with 12 inches as the practical minimum for a 6x6 in firm soil. Too narrow and there isn't enough concrete to resist the leverage the fence puts on the post.

Should concrete cover the top of the post hole?

Crown it above grade and slope it away from the post so water sheds off. Finishing the concrete flush or dished holds water against the post, which is exactly where rot starts.

How long does fast-setting concrete take for fence posts?

It sets in 20–40 minutes and holds the post firmly within about 4 hours, which is when rails and panels can go on. Wait 24 hours before hanging a gate, and longer in cold weather — full strength still takes the usual 28 days.

Can I set fence posts in gravel instead of concrete?

Yes, and for some soils it outperforms concrete. Compacted gravel drains freely so the post never sits in water, and it's far easier to replace a post later. It gives less lateral rigidity, so it suits post-and-rail better than tall solid privacy fences that catch wind.

Sources & Standards

Estimates for planning only. This calculator sizes material quantities. It does not size structural members, verify load paths, or confirm compliance with the code in your jurisdiction. Local requirements — frost depth, footing sizes, permits, and inspections — override anything here. Check with your local code enforcement office or building department before you build. They are the authority that inspects and signs off the work, they amend the model codes, and what they say overrides any figure on this page. For structural or safety-critical work, have the design checked by a licensed engineer or contractor as well. Dollar figures on this page are typical US planning ranges, not quotes: prices vary by region, supplier and season, so check current local prices before you budget. See our full method and assumptions.

Last updated · How we calculate